This two-day course offers an introduction to CONVERGE for
internal 
combustion (IC) engine modeling. You will learn about the
CONVERGE solver 
and modeling options while working through a typical IC
engine case from start 
to finish. Because CONVERGE has a completely automated
meshing process, 
you do not need to spend any time preparing the volume mesh,
which simplifies 
the case setup process.

During this course, you will have plenty of time for
hands-on practice in 
CONVERGE Studio. You will practice preparing the surface and
setting up the 
case for several types of IC engines (including diesel, PFI
spark-ignited and 
multi-fuel premixed).

Upon the completion of this course, you will know how to:
Set up solver parameters and data files
Set up appropriate boundary and initial conditions based on
available data
Control grid settings throughout the computational domain
Set up fuel injection via spray modeling
Set up detailed chemical kinetics for accurate combustion
and emissions 
modeling
Set up wall heat transfer modeling in CONVERGE and output
heat transfer 
quantities for thermal analysis
Set up additional modeling options such as turbulence and
sources
Run CONVERGE and monitor your simulation
Post-process results in CONVERGE Studio

PREREQUISITES
Surface Preparation with CONVERGE Studio for IC Engines

WHO SHOULD ATTEND THIS COURSE
This course is intended for all new users interested in
using CONVERGE for IC 
Engine modeling. This course can also be used as a refresher
for experienced 
or occasional users of previous versions of CONVERGE. This
course will not 
cover surface preparation.